Install TZM Server

From Tranzman Documentation
Revision as of 15:20, 16 July 2020 by Sachin (talk | contribs)
Jump to: navigation, search

This section explains how to install the Tranzman Server from files provided by Stone Ram Ltd.

Step 1

Power on your virtual/physical machine with the ISO file inserted for booting. On the first page, the EULA agreement has to be accepted before proceeding.

Use the "Page Down" key to cycle through the document. Press Q on the keyboard, followed by Y to accept the terms.

Step 2

The installer will scan the system for available hard drives.

Available Devices

Name Size sda 16G sdb 100G

Any existing data on the disk will be lost type "exit" to exit Please enter name of the disk to use >


Tranzman Server needs to be installed to the device "sda", so we type this on the selection. Type "exit" to abort the process if unsure, as all data will be lost on this device.


WARNING ! ALL DATA ON sda WILL BE LOST

Do you want to continue with sda? (Y/N) >y Installing Bootloader to sda [=======================================================================>] 100% Bootloader installed to sda with status <0>


sd 0:0:0:0: [sda] Assuming drive cache: write through

sd 0:0:0:0: [sda] Assuming drive cache: write through

Setting up boot partition on sda sd 0:0:0:0: [sda] Assuming drive cache: write through Completed with status <0>

Transfering data to boot partition on sda [===========================================================> ] 75% ETA 0:00:02


Step 3

Once the install process is finished, disconnect the install media and restart machine.

Install TZM install reboot.JPG

Step 4

The machine will look on the network for an available NTP and DHCP server. If you have a DHCP enabled environment and machine is able to get an IP from DHCP Server it will be displayed like in below image. Please login to the web using that IP and proceed with Configuration otherwise go to Step 5 to manually set an appliance IP.


Install TZM splash screen 01.JPG

Step 5

The appliance comes with a default account of "admin" and has a password of "P@ssw0rd". Change this default password as soon as possible for security reasons.

Log in to the CLI command and continue with the configuration of the server. If at any point, help with the commands is needed, press the "?" character on the keyboard to bring up suggestions on the screen.

Follow the commands shown in the below picture to manually set an appliance IP.


Install Manual IP 01.JPG


After the successfull completion of the above steps you should be able to login to the web console with a default account of "admin" and a password of "P@ssw0rd"

Jump to Configuration

Return to Installation