Difference between revisions of "Pre-Assessment"

Revision as of 14:26, 27 July 2020

The Tranzman Appliance can be used to carry out Pre-Assessment checks, allowing consultants to highlight pre-existing issues in the backup environment which needs to be resolved before the migration takes place.

Step 1:-

Go to Validation on the sidebar and click on Pre-Assessment.The page should look something like as shown below.

Step 2:-

Click on and this should start the Assessment job.The page will show the progress of the Assessment job. Wait for the job to finish.

Step 3:-

Once Pre-Assessment is finished the webpage should look like below where there will be two sections of Issues and Limitations.

Both sections of Issues and Limitations are further categorise in to Origin and Destination with respect to the test cases.

Any inconsistency in either Origin or Destination will be seen with a icon.

Make sure to resolve all the highlighted inconsistencies before proceeding with the migration.

Step 4:-

Pre-Assessment also enables you to review your backup Environments and Migration Plan

Note :- All the above steps are similar for any kind of migration.

Jump to Add Tape Library and NAS Connectors (For different vendor migration or recovery to files)

Jump to Check Transition Readiness (For same vendor migration )

Return to Select Migration Components