Configure Storage

From Tranzman Documentation
Revision as of 13:11, 6 September 2018 by Admin (talk | contribs)
Jump to: navigation, search

This page explains the process of configuring disks and volume configuration after a Tranzman Appliance installation.

After installation, the appliance will most likely only have one disk "sda" so we need to add more disks / volumes as stated in the "Planning and Sizing" section. This section assumes that a Tranzman Virtual Appliance is being used.

Step 1

Add en extra Hard Disk to the VA under the VMWare host.

Step 2

Make sure that the system can see the new disk.

> storage > show-all-disks