Difference between revisions of "Configure Storage"

From Tranzman Documentation
Jump to: navigation, search
Line 4: Line 4:
  
 
===Step 1===
 
===Step 1===
Add 5 extra Hard Disks to the VA under the VMWare host. For recomended sizes please refer to Step 14 on section [[Install VA]].
+
Add 5 extra Hard Disks to the VA under the VMWare host. For recomended sizes please refer to '''Step 14''' on section [[Install VA]].
  
 
===Step 2===
 
===Step 2===

Revision as of 13:42, 6 September 2018

This page explains the process of configuring disks and volume configuration after a Tranzman Appliance installation.

After installation, the appliance will most likely only have one disk "sda" so we need to add more disks / volumes as stated in the "Planning and Sizing" section. This section assumes that a Tranzman Virtual Appliance is being used.

Step 1

Add 5 extra Hard Disks to the VA under the VMWare host. For recomended sizes please refer to Step 14 on section Install VA.

Step 2

Make sure that the system can see the new disk.

> config > storage > show-available-disks Unable to configure disks Please check you have required [5] disks / partitions created

sdb pci-0000:00:10.0-scsi-0:0:1:0|VMware|Virtual disk|50G|UNKNOWN >