Difference between revisions of "Configure Storage"
From Tranzman Documentation
| Line 4: | Line 4: | ||
===Step 1=== | ===Step 1=== | ||
| − | Add | + | Add 5 extra Hard Disks to the VA under the VMWare host. For recomended sizes please refer to Step 14 on section [[Install VA Appliance for vSphere]] |
===Step 2=== | ===Step 2=== | ||
Revision as of 13:41, 6 September 2018
This page explains the process of configuring disks and volume configuration after a Tranzman Appliance installation.
After installation, the appliance will most likely only have one disk "sda" so we need to add more disks / volumes as stated in the "Planning and Sizing" section. This section assumes that a Tranzman Virtual Appliance is being used.
Step 1
Add 5 extra Hard Disks to the VA under the VMWare host. For recomended sizes please refer to Step 14 on section Install VA Appliance for vSphere
Step 2
Make sure that the system can see the new disk.
|
> config > storage > show-available-disks Unable to configure disks Please check you have required [5] disks / partitions created sdb pci-0000:00:10.0-scsi-0:0:1:0|VMware|Virtual disk|50G|UNKNOWN > |