Difference between revisions of "Configure Storage"

From Tranzman Documentation
Jump to: navigation, search
Line 1: Line 1:
 
This page explains the process of configuring disks and volume configuration after a Tranzman Appliance installation.
 
This page explains the process of configuring disks and volume configuration after a Tranzman Appliance installation.
  
[[File:Icon-pen.jpg]] After installation, the appliance will most likely only have one disk '''"sda"''' so we need to add more disks / volumes as stated in the '''"Planning and Sizing"''' section. This section assumes that a Tranzman Virtual Appliance is being used.
+
After installation, the appliance will most likely only have one disk '''"sda"''' so we need to add more disks / volumes as stated in the '''"Planning and Sizing"''' section. This section assumes that a Tranzman Virtual Appliance is being used.
  
 
===Step 1===
 
===Step 1===

Revision as of 13:07, 6 September 2018

This page explains the process of configuring disks and volume configuration after a Tranzman Appliance installation.

After installation, the appliance will most likely only have one disk "sda" so we need to add more disks / volumes as stated in the "Planning and Sizing" section. This section assumes that a Tranzman Virtual Appliance is being used.

Step 1

Add en extra Hard Disk to the VA under the VMWare host.

Step 2