Configure Storage
From Tranzman Documentation
This page explains the process of configuring disks and volume configuration after a Tranzman Appliance installation.
After installation, the appliance will most likely only have one disk "sda" so we need to add more disks / volumes as stated in the "Planning and Sizing" section. This section assumes that a Tranzman Virtual Appliance is being used.
Step 1
Add en extra Hard Disk to the VA under the VMWare host.
Step 2
Make sure that the system can see the new disk.
> config > storage > show-available-disks Unable to configure disks Please check you have required [5] disks / partitions created sdb pci-0000:00:10.0-scsi-0:0:1:0|VMware|Virtual disk|50G|UNKNOWN > |