Difference between revisions of "Configure Network"
m (Improve link text) |
|||
| Line 43: | Line 43: | ||
> config | > config | ||
> configure | > configure | ||
| − | > show | + | > network |
| + | > show-settings | ||
interface=eth0 | interface=eth0 | ||
dhcp=0 | dhcp=0 | ||
Revision as of 15:27, 17 May 2019
The default network behavior for the Tranzman appliance is to fall back to a DHCP configuration. As this is not desirable in many production environments, this section explains how to configure to a static IP address.
Step 1
Navigate to the network configuration on the appliance.
|
> config > network |
Step 2
Proceed to configure the network IP address and change the hostname if required.
Example:
|
> configure <interface> <fqdn> <ip> <mask> <gw> <port> Configure Hostname and Network interface name of interface (eg eth0) fqdn fully qualified hostname ip IP address for this appliance mask Network Mask eg. 255.255.255.0 gw IP address for default gateway port port to use for agents, default 55555 |
To change the IP address the command would be similar to the following;
|
> configure eth0 tzm_test.localdomain 192.168.1.100 255.255.255.0 192.168.50.254 55555 |
Step 3
After the network interface restarts, it is possible to re-connect to the appliance through the new static IP address.
New settings can be reviewed by navigating to the "config" menu.
To change the IP address the command would be similar to the following;
|
> config > configure > network > show-settings interface=eth0 dhcp=0 port=55555 fqdn=tzm_appliance.localdomain ip=192.168.1.100 mask=255.255.255.0 gw=192.168.1.254 dns=192.168.1.254 dnsb=UNDEFINED ntpserver=0.ntp.localdomain timezone=UTC |