Difference between revisions of "Configure Storage"
| Line 9: | Line 9: | ||
Make sure that the system can see the new disks. | Make sure that the system can see the new disks. | ||
| − | {| class="wikitable" style="padding-left: auto; color:#FFFFFF; background-color: black; width: | + | {| class="wikitable" style="padding-left: auto; color:#FFFFFF; background-color: black; width: 600px; FONT-FAMILY:monospace,monospace; LINE-HEIGHT:15px; white-space: pre-wrap; |
| | | | ||
> config | > config | ||
Revision as of 13:43, 6 September 2018
This page explains the process of configuring disks and volume configuration after a Tranzman Appliance installation.
After installation, the appliance will most likely only have one disk "sda" so we need to add more disks / volumes as stated in the "Planning and Sizing" section. This section assumes that a Tranzman Virtual Appliance is being used.
Step 1
Add 5 extra Hard Disks to the VA under the VMWare host. For recomended sizes please refer to Step 14 on section Install VA.
Step 2
Make sure that the system can see the new disks.
|
> config > storage > show-available-disks sdf pci-0000:00:10.0-scsi-0:0:5:0|VMware|Virtual disk|10G|N|UNKNOWN sde pci-0000:00:10.0-scsi-0:0:4:0|VMware|Virtual disk|10G|N|UNKNOWN sdd pci-0000:00:10.0-scsi-0:0:3:0|VMware|Virtual disk|2G|N|UNKNOWN sdc pci-0000:00:10.0-scsi-0:0:2:0|VMware|Virtual disk|16G|N|UNKNOWN sdb pci-0000:00:10.0-scsi-0:0:1:0|VMware|Virtual disk|50G|N|UNKNOWN sda pci-0000:00:10.0-scsi-0:0:0:0|VMware|Virtual disk|3G|Y|PARTITIONED > |