Difference between revisions of "Configure Storage"
From Tranzman Documentation
| Line 1: | Line 1: | ||
This page explains the process of configuring disks and volume configuration after a Tranzman Appliance installation. | This page explains the process of configuring disks and volume configuration after a Tranzman Appliance installation. | ||
| − | + | After installation, the appliance will most likely only have one disk '''"sda"''' so we need to add more disks / volumes as stated in the '''"Planning and Sizing"''' section. This section assumes that a Tranzman Virtual Appliance is being used. | |
===Step 1=== | ===Step 1=== | ||
Revision as of 13:07, 6 September 2018
This page explains the process of configuring disks and volume configuration after a Tranzman Appliance installation.
After installation, the appliance will most likely only have one disk "sda" so we need to add more disks / volumes as stated in the "Planning and Sizing" section. This section assumes that a Tranzman Virtual Appliance is being used.
Step 1
Add en extra Hard Disk to the VA under the VMWare host.